HKSpot - Powered by Discuz! Board

標題: [硬件] 伏已中！Buffalo WHR-HP-G300N wifi無故失蹤 [打印本頁]

作者: rickywk 時間: 2011-7-27 13:40 標題: 伏已中！Buffalo WHR-HP-G300N wifi無故失蹤

應該係DD-WRT唔夾呢隻o野，但flash返原裝buffalo firmware又超複雜，要睇下屋企有冇士啤router/switch可以擺o係公司用一排，然後自己慢慢攪

作者: ccw 時間: 2011-7-27 14:15

引用:

原帖由 rickywk 於 2011-7-27 13:40 發表
應該係DD-WRT唔夾呢隻o野，但flash返原裝buffalo firmware又超複雜，要睇下屋企有冇士啤router/switch可以擺o係公司用一排，然後自己慢慢攪

flash返原裝buffalo firmware又超複雜
Not really, you just need a official firmware and TFTP,
I usually get it done with Linux(ubuntu installed/Live).

Follow this guide:
http://g300nh.blogspot.com/2010/ ... brick-recovery.html

and use this MAC instead of the mentioned in the guide:
02:AA:BB:CC:DD:1A
(refer to this link http://www.dd-wrt.com/phpBB2/viewtopic.php?t=87579)

After transferring, wait about 10-15mins until the red diag light goes(make sure it is complete before you cut the power or restart, sometimes it is just off for a while).
And it will be ok.

OR

There is a simply firmware that allows you to go back to firmware by firmware update in dd-wrt......
but I was once fail(though I have succeeded before) and killed my router using it.
But the link is dead, you may need to search for it.

[ 本帖最後由 ccw 於 2011-7-27 14:35 編輯 ]

作者: rickywk 時間: 2011-7-27 14:17

引用:

原帖由 ccw 於 2011-7-27 14:15 發表

flash返原裝buffalo firmware又超複雜
Not really, you just need a official firmware and TFTP,
I usually get it done with Linux(ubuntu installed/Live).

Follow this guide:
http://g300nh.blogspot.com/201 ...

我知，但隻o野個位唔o係我附近嘛，又驚變磚，所以"一換一"式甩o左佢出o黎先再攪

其實變磚仲好，一o野踢返俾漢科 :Dev:

作者: ccw 時間: 2011-7-27 14:34

引用:

原帖由 rickywk 於 2011-7-27 14:17 發表

我知，但隻o野個位唔o係我附近嘛，又驚變磚，所以"一換一"式甩o左佢出o黎先再攪

其實變磚仲好，一o野踢返俾漢科 :Dev:

Yes, completely Bricked = replacement, partial brick(red diag can still light) they may void your warranty for modification.

歡迎光臨 HKSpot (https://bbs.hk-spot.com/)