HKSpot - Powered by Discuz! Board

標題: [硬件] INTEL ATOM 2800MT [打印本頁]

作者: 愚生 時間: 2013-6-4 13:46 標題: INTEL ATOM 2800MT

Memory
Two SO-DIMM slots for 1066/800 MHz DDR3 single-channel memorySupport for up to 4 GB of system memory

如果咁寫可唔可以行到單一條4G NB BOOK RAM ?? 或 4G X 2 得唔得？

作者: qcmadness 時間: 2013-6-4 13:58

1*4 maybe ok
2*4 not ok

作者: pk1667 時間: 2013-6-4 14:00

引用:

原帖由愚生於 2013-6-4 13:46 發表
Memory
Two SO-DIMM slots for 1066/800 MHz DDR3 single-channel memorySupport for up to 4 GB of system memory

如果咁寫可唔可以行到單一條4G NB BOOK RAM ?? 或 4G X 2 得唔得？

唔可以, 只可插 1x4GB or 2x2GB
http://downloadmirror.intel.com/ ... Guide02_English.pdf

作者: 愚生 時間: 2013-6-4 14:19

引用:

原帖由 pk1667 於 2013-6-4 14:00 發表

唔可以, 只可插 1x4GB or 2x2GB
http://downloadmirror.intel.com/ ... Guide02_English.pdf

好詳細 THX

原來我可以用其他火牛！唔一定12V

Connecting to a Power Supply
The board supports a wide range of input voltages from either of the following power
supply types:
• External Power Supply – the board can be powered with an 8-19 V DC external
power supply though the DC jack on the back panel (Figure 13, A). This connector
accepts dual-barrel plugs with an inner diameter (ID) of 2.5 mm and an outer
diameter (OD) of 5.5 mm, where the inner contact is +8 V DC (±10 %) through
+19 V DC (±10 %) and the shell is Ground. The maximum current rating for this
connector is 8 A.
• Internal Power Supply – the board can alternatively be powered through the
internal 1 x 2 power connector (Figure 13, B), where pin 1 is Ground and pin 2 is
+8 V DC (±10 %) through +19 V DC (±10 %). The maximum current rating for
this connector is 10 A.
Use of an external power supply is preferred. Total power consumption depends on
the system configuration selected by the integrator. Refer to the Intel Desktop Board
DN2800MT Technical Product Specification for further guidance.

歡迎光臨 HKSpot (https://bbs.hk-spot.com/)